Start » Filter Reference » Hardware Support » BitFlow » BitFlow_ReadValueFromRegister
Basic| Module: | ThirdParty |
|---|
Reads a value from a register.
| Name | Type | Description | |
|---|---|---|---|
 |
inBoardNumber | Integer | Index of board |
|
inCameraFileName | File | Camera file |
|
inRegId | Integer | Register Id |
 |
outValue | Integer | Register value |
Remarks
Board driver software
This filter is intended to cooperate with board using its vendor SDK. To be able to connect with board it is required to install BitFlow SDK software. Currently Aurora Vision Studio requires BitFlow SDK version 6.30.
BitFlow SDK can be downloaded from following website: http://www.bitflow.com (registration may be required).
Running application
This filter uses camera configuration files, which are loaded to register. To load this file to register you should use SysReg application from BitFlow SDK.Registers management
Register IDs are declared in "BFTabRegister.h" located in Bitflow SDK. See the corresponding Bitflow Hardware Reference Manual for a description of each bit.
Parallel execution
This filter cannot be placed in multiple Workers.
Complexity Level
This filter is available on Basic Complexity Level.
Disabled in Lite Edition
This filter is disabled in Lite Edition. It is available only in full, Aurora Vision Studio Professional version.
See Also
- BitFlow_WriteValueToRegister – Writes a value to a register.
- BitFlow_GetRegisterName – Gets a register name.