Start » Filter Reference » Camera Support » NET SynView » SynView_GetDigitalIOStates
Module: | ThirdParty |
---|
Gets SynView digital IO states.
Name | Type | Range | Description | |
---|---|---|---|---|
inDeviceID | String* | Tries to find the camera in all available IDs (UserID, VendorName, ModelName...) | ||
inLineNumber | Integer | 1 - 32 | I/O line for querying | |
outState | Bool | Current status of the selected line |
Description
This filter gets the logical state of the selected Digital IO line.
The line mapping is fixed for all camera families - all PicSight and CheckSight models. It's briefly summarized in the following table, details are listed in SynView Manual Sections: "Input and output signals" and "Connector and cable description".
I/O lines | Mapped signals |
Line1 - Line4 | Optocoupler inputs |
Line5 - Line8 | Reserved |
Line9 - Line12 | Optocoupler outputs |
Line13 - Line16 | Reserved |
Line17 - Line18 | TTL inputs |
Line19 - Line24 | Reserved |
Line25 - Line26 | TTL outputs |
Line27 - Line32 | Reserved |
Remarks
Camera driver software
This filter is intended to cooperate with cameras using their vendor's SDK. In order to connect with the camera, it is required to install SynView SDK software with camera dedicated drivers.
SynView SDK can be downloaded from the following website: https://net-gmbh.com/en/machine-vision/products/software
To verify the driver installation, you can run SynView Explorer (in the directory where camera drivers where installed). If the camera was detected and you can see the view from the camera, you can use SynView camera SDK in Aurora Vision Studio.
Recommended SynView SDK version for Aurora Vision Studio usage is 1.03.010.
Camera identification
When there is only one camera connected, the field inDeviceID can be set to Auto. In this situation, the first available camera will be used.
inDeviceID can be used to pick one of multiple cameras connected to the computer. DeviceID can be set to:
- UserID - User ID (also known as nickname) of the selected device,
- VendorName - Name of the manufacturer of the device,
- ModelName - Model name of the device,
- DisplayName - Device display name,
- IPAddress - Current IP address of the selected device (GigE Vision devices only),
- MACAddress - MAC address of the selected device (GigE Vision devices only),
- SerialNumber - String representation of camera's unique serial number.
Complexity Level
This filter is available on Basic Complexity Level.
Disabled in Lite Edition
See Also
- SynView_ConfigureDigitalIO – Configures SynView digital IO.
- SynView_ConfigureTimer – Configures one of the internal hardware timers available in the camera.
- SynView_GrabImage – Captures a frame using SynView.
- SynView_SetUserOutput – Sets SynView user outputs.