Start » Filter Reference » Hardware Support » Matrox » Matrox_RegisterImpulse

Matrox_RegisterImpulse

Advanced

Module: ThirdParty

Registers an impulse in a command list.

Name Type Range Description
Input value
 inDeviceID MatroxSystemAndDeviceIdentifier* Device identification.
Input value
 inCommandList Integer 1 - 2 I/O command list.
Input value
 inCommandBit Integer 0 - 7 Bit of the command list.
Input value
 inReferenceMoment Long* Value of counter for which the command is to be registered (in seconds or counts).
Input value
 inDelay Real 0.0 - Delay from the specified counter value.

Remarks

I/O device driver software

This filter is intended to cooperate with a Matrox device using its vendor SDK. To be able to connect to the device, it is required to install Matrox MIL X SDK. Matrox industrial PCs usually come with a preinstalled runtime license.

Add DLL path to system environment variable may be required.

Recommended Matrox MIL X SDK version for Aurora Vision Studio usage is V22H1 (10.50.924).

Device identification

Device field can be used to specify the number (rank) of the target board of the specified system type. Device can be set to:

  • DEFAULT - Specifies the default board. The default board is set in the MILConfig utility.
  • DEVn - Specifies the device number (rank) of the board (where 0 <= n <=15).

System field can be used to specify the system type. System can be set to:

  • HOST - Specifies the default build-in system like IO in industrial PC.
  • CONCORD - Specifies the IO system from Concord framegrabber.

This filter allows to register an impulse in one of the command lists. The specified command list must be configured using Matrox_ConfigureIOCommandList prior to using this filter.

Complexity Level

This filter is available on Advanced Complexity Level.

Disabled in Lite Edition

This filter is disabled in Lite Edition. It is available only in full, Aurora Vision Studio Professional version.

See Also