Start » Filter Reference » Hardware Support » Euresys » MultiCam_GrabImage
Module: | ThirdParty |
---|
Captures a frame using Euresys frame grabber.
Name | Type | Range | Description | |
---|---|---|---|---|
inDeviceID | String* | Board name, board identifier or serial number | ||
inTopology | String* | Board topology | ||
inCameraTapConfiguration | String* | Tap configuration of camera | ||
inConnector | String | Indication of connector used by channel | ||
inAcquisitionMode | MultiCamAcquisitionMode | Acquisition Mode | ||
inCameraFile | File* | Camera configuration file | ||
inPageLengthLn | Integer* | 1 - 65535 | Page Length | |
inColorFormat | MultiCamColorFormat | Color format | ||
inGain | Integer* | Linear control of gain for all digitizing units | ||
inSurfaceCount | Integer* | 1 - 4096 | Number of allocated surfaces | |
outImage | Image | Captured frame | ||
outFrameID | Long | Captured frame ID | ||
outTimestamp | Long | Captured frame timestamp in microseconds |
Remarks
Board driver software
This filter is intended to cooperate with board using its vendor SDK. To be able to connect with board it is required to install MultiCam SDK software. Currently Aurora Vision Studio requires MultiCam version 6.18.
MultiCam drivers can be downloaded from following website: https://www.euresys.com (registration may be required).
Supported frame grabbers:
- GRABLINK series
- DOMINO series
- Picolo series
Board identification
When there is only one board connected to the computer, field inDeviceID can be set to Auto. In such case, first available board will be found and connected.
inDeviceID can be used to pick one of multiple boards connected to the computer. inDeviceID can be set to:
- board name,
- board identifier,
- driver index,
- pci position.
Parallel execution
Complexity Level
This filter is available on Basic Complexity Level.
Filter Group
This filter is member of MultiCam_GrabImage filter group.
See Also
- MultiCam_StartAcquisition – Initializes and starts image acquisition by frame grabber.
- MultiCam_GetDigitalInput – Reporting the logic state of I/O lines used as inputs.
- MultiCam_SetDigitalOutput – Sets digital output.