Start » Filter Reference » Hardware Support » Euresys » MultiCam_SetDigitalOutput

MultiCam_SetDigitalOutput

Basic

Module: ThirdParty

Sets digital output.

Name Type Description
Input value
 inDeviceID String* Board name, board identifier or serial number
Input value
 inOutput Integer Output pin index
Input value
 inOutputStyle MultiCamOutputStyle* Controlling the electrical style of I/O lines used as outputs. If Nil then lease style as it is
Input value
 inOutputState MultiCamOutputState Issuing the logic state of I/O lines used as outputs

Remarks

Board driver software

This filter is intended to cooperate with board using its vendor SDK. To be able to connect with board it is required to install MultiCam SDK software. Currently Aurora Vision Studio requires MultiCam version 6.18.

MultiCam drivers can be downloaded from following website: https://www.euresys.com (registration may be required).

Supported frame grabbers:
  • GRABLINK series
  • DOMINO series
  • Picolo series
Board identification

When there is only one board connected to the computer, field inDeviceID can be set to Auto. In such case, first available board will be found and connected.

inDeviceID can be used to pick one of multiple boards connected to the computer. inDeviceID can be set to:

  • board name,
  • board identifier,
  • driver index,
  • pci position.

Parallel execution

This filter cannot be placed in multiple Workers.

Complexity Level

This filter is available on Basic Complexity Level.

Disabled in Lite Edition

This filter is disabled in Lite Edition. It is available only in full, Aurora Vision Studio Professional version.

See Also